Calculating Power Margin For Fiber-Optic Cable For M Series, Mx Series, And T Series Routers; Table 26: Estimated Values For Factors Causing Link Loss - Juniper M10i Hardware Manual

M10i Multiservice Edge Router Hardware Guide
Related
Documentation

Calculating Power Margin for Fiber-Optic Cable for M Series, MX Series, and T Series Routers

198
All manuals and user guides at all-guides.com
The following hypothetical power budget equation uses values measured in decibels
(dB) and decibels referred to one milliwatt (dBm):
P = P – P
B T R
P = –15 dBm – (–28 dBm)
B
P = 13 dB
B
Fiber-Optic and Network Cable Specifications for M10i Routers on page 195
Signal Loss in Multimode and Single-Mode Fiber-Optic Cable for M10i Routers on
page 196
Attenuation and Dispersion in Fiber-Optic Cable on M Series, MX Series, and T Series
Routers on page 196
Calculating Power Margin for Fiber-Optic Cable for M Series, MX Series, and T Series
Routers on page 198
After calculating a link's power budget you can calculate the power margin (
represents the amount of power available after subtracting attenuation or link loss (
from the power budget ( P
B
P = P – LL
M B
A P greater than zero indicates that the power budget is sufficient to operate the receiver.
M
Factors that can cause link loss include higher-order mode losses (HOL), modal and
chromatic dispersion, connectors, splices, and fiber attenuation. Table 26 on page 198
lists an estimated amount of loss for the factors used in the following sample calculations.
For information about the actual amount of signal loss caused by equipment and other
factors, refer to vendor documentation.

Table 26: Estimated Values for Factors Causing Link Loss

Link-Loss Factor
Higher-order mode losses
Modal and chromatic dispersion
Connector
Splice
). A worst-case estimate of
Estimated Link-Loss Value
Single-mode—None
Multimode—0.5 dB
Single-mode—None
Multimode—None, if product of bandwidth and distance
is less than 500 MHz-km
0.5 dB
0.5 dB
), which
P
M
P assumes maximum LL :
M
Copyright © 2010, Juniper Networks, Inc.
LL )