RH Baby&child BELLAMY Assembly Instructions

BELLAMY HAND-CARVED ROUND MIRROR - ASSEMBLY INSTRUCTIONS
PARTS ENCLOSED:
A [1] BELLAMY HAND-CARVED ROUND MIRROR
B [1] HANGMAN (FOR WALL)
Note: This hanging system is meant for drywall/stud mounting only. If walls are concrete,
your local hardware store for assistance. For safety and ease of mounting, two people are recommended for installation.
PROFESSIONAL INSTALLATION RECOMMENDED
Tools needed:
Electronic stud finder, #2 Phillips screwdriver, drill with #2 Phillips bit, pencil
Mounting Instructions:
1. Determine the desired placement on the wall for the mirror. Within the desired mounting location, locate the wall studs
using the electronic stud finder and mark stud locations using the pencil. ( N ote: It is best to mount the bracket to at least
one stud, a s shown in the illustration above.)
2. Determine which wall mount bracket hole(s) will be centered on a stud. The hole positions that are centered over studs
will use the stud mounting screws for mounting the bracket.
3. Insert the included bubble level into the bubble level track, as close to the center of the wall mount bracket as possible.
4. Place the wall mount bracket at the desired location on the wall. Use the bubble level to confirm that the bracket is level.
5. Mark the mounting screw hole locations on the wall with the pencil.
6. Remove the wall mount bracket and set aside.
Stud Mounting:
1. Install the wall mount bracket onto the wall using the stud mounting screw at one of the stud locations first, using the #2
Phillips screwdriver or the drill with a #2 Phillips bit.
2. Insert the firs t stud mounting screw through the hole in the wall mount bracket and tig hten clockwise. Leave the s tud
mounting screw slightly loose so that the wall mount bracket can still be rotated and the w a l l mount bracket area on the
wall is exposed for installing the drywall toggle anchor(s).
Drywall Mounting:
1. Use the #2 Phillips screwdriver to install the toggle anchor(s).
Hanging the Product:
1. On the back of your mirror is an affixed product-mounting bracket.
2. Carefully position the product-mounting bracket over the wall mount bracket, ensuring that the two brackets are aligned.
3. Press down firmly to engage the two brackets.
4. Your product is ready for use.
NO. ITEM
DESCRIPTION
Toggle Anchors
1
2
Toggle Screws
3
Stud Mounting Screws
4
Toggle EZ Mini Anchors
5
Toggle EZ Screws
6
Bubble Level
EZ Mini
QTY
2 Pcs.
2 Pcs.
7 Pcs.
2 Pcs.
2 Pcs.
1 Pc.
brick or plaster, please consult
EZ Mini