RH Baby&child BELLINA DRESSER Quick Start Manual

Table of Contents

Download this manual

Customer Service - If you are missing parts or have any questions about this product, please

A. [1] BELLINA DRESSER

B. [4] LEG

STEP #1:

Gently lay Bellina Dresser on its back on a flat and non-abrasive surface.

Note:

On the bottom of the dresser are holes with pre-installed nuts that correspond to the

threaded rods pre-installed in the legs.

STEP #2:

Align and insert the threaded rod of the leg into the hole and turn clockwise to tighten.

Please see sketch below.

Note: do not over tighten.

STEP #3:

After assembly, gently lift the dresser into upright position.

B E L L I N A D R E S S E R

ADULT ASSEMBLY ONLY OWING TO THE PRESENCE OF SMALL

PARTS, SHARP POINTS AND EDGES

Table of Contents

Need help?

Do you have a question about the BELLINA DRESSER and is the answer not in the manual?

Page 1 B. [4] LEG INSTRUCTIONS: STEP #1: Gently lay Bellina Dresser on its back on a flat and non-abrasive surface. Note: On the bottom of the dresser are holes with pre-installed nuts that correspond to the threaded rods pre-installed in the legs.
Page 2 FURNITURE TIPPING RESTRAINT INSTRUCTIONS Young children may be injured by tipping furniture and the use of a tipping restraint is highly recommended. When properly installed, this restraint could provide protection against the unexpected tipping of furniture due to small tremors, bumps or climbing. We recommend mounting this restraint to a wall stud. WARNING : This product is only a deterrent.
Page 3 This changing table is intended for use with children weighing up to 50 pounds. Bellina Dresser Topper will be used with Bellina Dresser (sold separately) with size 42" W x 19.5"x 33 H. Cushion pad size is 32"L x 16"W x 4"H.

Bellina dresser topper