Tools And Equipment; Installation Guidelines - Cisco C1000-8T-2G-L Installation Manual

Tools and Equipment

3
4
5
6
7
1
2
3

Tools and Equipment

Obtain these necessary tools:
• A Number-2 Phillips screwdriver.
• Drill with #27 drill bit (0.144-inch [3.7 mm]) for mounting an 8-port and 16-port switch.

Installation Guidelines

When determining where to install the switch, verify that these guidelines are met:
• Clearance to the switch's front and rear panel should meet these conditions:
• Cabling is away from sources of electrical noise, such as radios, power lines, and fluorescent lighting
• Airflow around the switch and through the vents is unrestricted. To avoid any flow blockage, we strongly
Cisco Catalyst 1000 Series 8-Port and 16-Port Switch Hardware Installation Guide
18
Four rubber mounting feet (51-0089)
Compliance documentation
(78-101287-01)
Three number-8 screws (48-1689-01)
Screw template (47-100996-02)
(Optional) Console cable or USB cable
for C1000-8T-E-2G-L and C1000-16T-E-2G-L switch models
for C1000-8P-E-2G-L switch models
for C1000-8FP-E-2G-L and C1000-16P-E-2G-L switch models
• Front-panel LEDs can be easily read.
• Access to ports is sufficient for unrestricted cabling.
• AC power cord can reach from the AC power outlet to the connector on the switch's rear panel.
fixtures. Make sure that the cabling is safely away from other devices that might damage the cables.
recommend these guidelines:
• Allow at least 3 in. (7.6 cm) of clearance from the left and the right sides, and the front and rear of
the switch.
• Allow at least 1.75 in. (4 cm) of clearance from the top cover, if you are installing the switch in
upright position.
• Allow at least 3 in. (7.6 cm) of clearance from the top cover, if you are installing the switch.
10 (Optional) DIN rail mount
(only with Cisco Catalyst 1000 16-port
switch models)
11 Power Adaptor - PWR-ADPT-18W
12 Power Adaptor - PWR-ADPT-85W
13 Power Adaptor - PWR-ADPT-150W
Switch Installation
1
2
3