Cisco C1000-8T-2G-L Installation Manual page 23

Switch Installation
Warning
Class 1 laser product. Statement 1008
Warning
There is the danger of explosion if the battery is replaced incorrectly. Replace the battery only with the same
or equivalent type recommended by the manufacturer. Dispose of used batteries according to the manufacturer's
instructions. Statement 1015
Warning This unit is intended for installation in restricted access areas. A restricted access area can be accessed only
through the use of a special tool, lock and key, or other means of security. Statement 1017
Warning
Take care when connecting units to the supply circuit so that wiring is not overloaded. Statement 1018
Warning
The plug-socket combination must be accessible at all times, because it serves as the main disconnecting
device. Statement 1019
Warning This equipment must be grounded. Never defeat the ground conductor or operate the equipment in the absence
of a suitably installed ground conductor. Contact the appropriate electrical inspection authority or an electrician
if you are uncertain that suitable grounding is available. Statement 1024
Warning Class 1 LED product. Statement 1027
Warning Only trained and qualified personnel should be allowed to install, replace, or service this equipment. Statement
1030
Warning Ultimate disposal of this product should be handled according to all national laws and regulations. Statement
1040
Warning When installing or replacing the unit, the ground connection must always be made first and disconnected last.
Statement 1046
Cisco Catalyst 1000 Series 8-Port and 16-Port Switch Hardware Installation Guide
Safety Warnings
13