Table of Contents
Advertisement
COM (Serial) Ports
COM 2
COM 1/COM 2:
RS232
COM 1
1 2 3 4 5
6 7 8 9
COM 1 and COM 2 are fixed at RS232.
The serial ports are asynchronous communication ports with 16C550A-compatible UARTs that
can be used with modems, serial printers, remote display terminals, and other serial devices.
Connecting External Serial Ports
Your COM port may come mounted on a card-edge bracket. Install the card-edge bracket to
an available slot at the rear of the system chassis then insert the serial port cable to the COM
connector. Make sure the colored stripe on the ribbon cable is aligned with pin 1 of the COM
connector.
BIOS Setting
Configure the serial COM ports in the Advanced menu ("Super IO Configuration" submenu) of
the BIOS. Refer to the chapter 3 for more information.
Chapter 2 Hardware Installation
Chapter 2
Graphics Interfaces
The display ports consist of the following:
•
1 DVI-I port
•
1 HDMI port
DVI-I
HDMI
DVI-I Port
The DVI-I port is used to connect an LCD monitor. This port supports DVI-D signal only.
Connect the display device's cable connector to the DVI-I port. After plugging the cable con-
nector into the port, gently tighten the cable screws to hold the connector in place.
HDMI Port
The HDMI port which carries both digital audio and video signals is used to connect a LCD
monitor or digital TV that has the HDMI port.
BIOS Setting
Configure the display devices in the Chipset menu ("System Agent Configuration" submenu) of
the BIOS. Refer to the chapter 3 for more information.
22
www.dfi .com
Advertisement
Table of Contents
