Switching Off The Appliance; Device Control; Installation Of The Device - Electrolux ECH/AT-1500 3AI-W EEC User Manual

Electric convection heater
Hide thumbs Also See for ECH/AT-1500 3AI-W EEC:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1

Switching off the appliance

To turn off the device, press the button
in any operating mode.

Device control

Preparation for work
1. Carefully remove the heater from the
cardboard box.
2. Remove the colored stickers from the front
panel before use.
3. At the first start-up, some odor may
appear, which will disappear after the
convector starts to work.
4. Fix the device in a stable position
according to the assembly and installation
instructions.
5. After installing the convector, plug it into a
power outlet.
6. It is not recommended to use the same
electrical outlet for simultaneous plugging
in heater and other high power electrical
appliance.

Installation of the device

Recommended installation
The device must be fixed in accordance with
the regulations.
The switch and other mechanisms must
stay away from splashing water. It is strictly
forbidden to cover or plug the air inlets or
outlets (grilles), due to the risk of accident or
damage to the device. Do not place behind
curtains, doors, wall or air vents. Observe
the minimum installation distances on floors,
surfaces, furniture, etc.
.
100 mm
min.
Figure. 5
1. Wall mounted installation option
(bracket and mounting template
included)
Use the brackets to mount the heater on
the wall according to the pictures below.
The distance from the device to the floor
and surrounding objects must be at least 10
cm (Figure 5):
To install the bracket on a wall, follow these
steps:
Fix the device to the bracket as follows
(Figure 6):
100 mm
min.
100 mm
min.
100 mm
min.
Attach the mounting template to the wall
in the place where you plan to place
the vector.
Mark and drill holes.
Place the bracket on the wall and secure
it with the fasteners.
Place the lower part of
the bracket using the special holes located
in the lower part of the convector.
Slide the upper part of the convector onto
the bracket, fixing it with the latches on the
bracket.
b
a
Figure. 6
Figure. 7
ENGLISH
the convector onto
9

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ech/at-2000 3ai-w eecEch/at-2500 3ai-w eec

Table of Contents