"Overheating Protection" Function; Switching Off The Appliance; Device Control; Installation Of The Device - Electrolux ECH/AG2-1300 3BE EEC User Manual

"Auto Restart Resume" function
In the event of a short-term power outage,
and its further inclusion, the convector
automatically switches to the operating mode,
while maintaining the last operating mode of
the device and the set temperature (if a timer
was set, the set shutdown time is saved). If the
device was in standby mode when the power
was turned off, it will remain in the same mode
when the power supply is restored.

"Overheating protection" function

The device is equipped with an automatic
switch that is activated when the upper
temperature limit is reached. The heater
switches off automatically in case of
overheating. After eliminating the source
of overheating, the heater will turn on
automatically.

Switching off the appliance

To turn off the device, press the button
in any operating mode.

Device control

Preparation for work
1. Carefully remove the heater from the
cardboard box.
2. Remove the colored stickers from the front
panel before use.
3. At the first start-up, some odor may
appear, which will disappear after the
convector starts to work.
4. Fix the device in a stable position
according to the assembly and installation
instructions.
5. After installing the convector, plug it into a
power outlet.
6. It is not recommended to use the same
electrical outlet for simultaneous plugging
in heater and other high power electrical
appliance.
Wi-Fi Pairing Mode
To put the Wi-Fi module in Pairing mode,
you must press the and buttons
simultaneously for 2 seconds. The Wi-Fi icon will
start blinking once per second.If the connection
is successful, the Wi-Fi icon will start to light up
steadily.
* If there is no micathermic heating element, this icon is never lit.
Wi-Fi statuses:
• The icon is not lit - the device is not
connected;
• Icon blinking - pairing mode;
• The icon lights up - the device is
connected.
Micathermic heating element *
To turn on the micathermic heating element,
simultaneously press the
seconds.
The icon of the micro thermal heating element
will light up.
This means that in addition to the main
heating element, the micathermic one will also
operate.

Installation of the device

Recommended installation
The device must be fixed in accordance with
the regulations.
The switch and other mechanisms must
stay away from splashing water. It is strictly
forbidden to cover or plug the air inlets or
outlets (grilles), due to the risk of accident or
damage to the device. Do not place behind
curtains, doors, wall or air vents. Observe
the minimum installation distances on floors,
surfaces, furniture, etc.
100 mm
min.
1. Wall mounted installation option
(bracket and mounting template
included)
Use the brackets to mount the heater on
and
the wall according to the pictures below.
The distance from the device to the floor
and surrounding objects must be at least 10
cm (Figure 5):
ENGLISH
and for 2
100 mm
min.
100 mm
min.
100 mm
min.
Figure. 5
7