Care; Troubleshooting - Electrolux ECH/AT-1500 3AI-W EEC User Manual

10 www.home-comfort.com
2. Floor installation
Using the chassis (supplied separately), having
previously studied the mounting scheme
(Figure 7), install the device on the floor:
1. Carefully turn the convector upside down.
2. Take one of the chassis and attach to
the landing area on the right or left side
of the convector so that it fits snugly
against the convector body
3. Secure the chassis using the supplied
mount.
4. Repeat the same procedure for attaching
the second chassis.

Care

The convector does not require any special
maintenance. Before servicing (leaving)

Troubleshooting

Malfunction
symptom
No heating
Smell of burnt dust
when first turned on
If after trying all the troubleshooting steps, the problem is not resolved, contact an authorized service cen-
ter in your area or your sales representative.
Cause of malfunction
1) There is no power supply.
2) The convector is in standby mode.
3) The actual room temperature is higher
than the thermostat setting.
Not a malfunction
the convector must be disconnected from
the power supply.
The body of the device should be periodically
wiped with a soft, lint-free cloth or damp
sponge. Never use abrasive, foaming
detergents or solvents. It is quite easy to clean
the space behind a wall-mounted heater.
Press down the two latches on the back of
the heater and pull the heater forward. After
it is removed, you can wash the wall on which
it was installed.
After finishing cleaning, put the heater back
in its normal operating position.
Recommended indoor temperature
and humidity:
a) for the convector operation: from -25°С
to + 30°С, humidity from 40% to 90%;
b) for the storage of the convector: from -20°C
to + 80°С, humidity from 40% to 90%.
Troubleshooting steps
1) Establish a reliable connection.
2) Set the convector to operating
mode.
3) Adjust the temperature mode of the
convector.
The smell disappears after a few
minutes of convector operation