Table of Contents
Advertisement
Available languages
Available languages
To activate the user mode, press the button
for 2 seconds. The icon «M» lights up. To
control the heating steps, press the button
once.
"Open window" function
When this function is active, when the
temperature drops within 10 minutes (and then
up to 30 minutes) by 5 or more degrees -
the Anti-Frost mode is switched on the heater.
If in the time interval 10 - 30 minutes the
temperature continues to drop, the device
turns off. Further, the heater waits for the
stabilization of the decrease in the room
temperature, if it rises by 2 degrees, then
the last set mode is turned on.
To activate/deactivate the control panel lock
of the control panel, press the
"Parental control" function
To activate/deactivate the control panel lock
of the control panel, press the buttons
for 12 seconds at the same time.
"Auto Restart Resume" function
In the event of a short-term power outage,
and its further inclusion, the convector
automatically switches to the operating mode,
while maintaining the last operating mode of
the device and the set temperature (if a timer
was set, the set shutdown time is saved). If the
device was in standby mode when the power
was turned off, it will remain in the same mode
when the power supply is restored.
"Overheating protection" function
The device is equipped with an automatic
switch that is activated when the upper
temperature limit is reached. The heater
switches off automatically in case of
overheating. After eliminating the source
of overheating, the heater will turn on
automatically.
Switching off the appliance
To turn off the device, press the button
in any operating mode.
Device control
Preparation for work
1. Carefully remove the heater from the
cardboard box.
2. Remove the colored stickers from the front
panel before use.
3. At the first start-up, some odor may
appear, which will disappear after the
convector starts to work.
4. Fix the device in a stable position
according to the assembly and installation
instructions.
5. After installing the convector, plug it into a
power outlet.
It is not recommended to use the same elec-
trical outlet for simultaneous plugging in heat-
er and other high power electrical appliance.
.
Pairing mode
To do this, press the and buttons
simultaneously for 2 seconds. The Wi-Fi icon
and
will start blinking once per second. If the
connection is successful, the Wi-Fi icon The
Wi-Fi icon lights steadily.
Wi-Fi statuses
•
The icon is not lit - the device is not
connected;
•
Icon blinking - pairing mode;
•
The icon lights up - the device is
connected.
Installation of the device
Recommended installation
The device must be fixed in accordance with
the regulations.
The switch and other mechanisms must
stay away from splashing water. It is strictly
forbidden to cover or plug the air inlets or
outlets (grilles), due to the risk of accident or
damage to the device. Do not place behind
curtains, doors, wall or air vents. Observe
the minimum installation distances on floors,
surfaces, furniture, etc.
.
100 mm
min.
ENGLISH
and
100 mm
min.
100 mm
min.
100 mm
min.
Figure. 5
7
Advertisement
Chapters
Table of Contents
