Power connector cable
Description
Power connector cable
Before removing the power connector cable, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4.
Remove the battery (see
●
Optical drive (see
●
Hard drive (see
●
Keyboard (see
●
Top cover (see
Remove the power connector cable:
1.
Release the power connector cable from the clips (1) built into the base enclosure.
2.
Disconnect the power connector cable (2) from the system board.
3.
Remove the two Phillips PM2.0×4.0 screws (3) that secure the power connector to the
base enclosure.
80
Chapter 4 Removal and replacement procedures
Battery on page
47), and then remove the following components:
Optical drive on page
Hard drive on page
51)
Keyboard on page
59)
Top cover on page
62)
48)
Spare part number
665596-001