Membrane Decal - Genie S-100 Service Manual

First Edition • First Printing
PLATFORM CONTROLS
3 Locate the membrane circuit board mounted to
the inside of the platform control box lid.
Electrocution hazard. Contact with
electrically charged circuits could
result in death or serious injury.
Remove all rings, watches and
other jewelry.
Component damage hazard.
Electrostatic discharge (ESD) can
damage printed circuit board
components. Maintain firm contact
with a metal part of the machine
that is grounded at all times when
handling printed circuit boards OR
use a grounded wrist strap.
4 Carefully disconnect the two ribbon cables from
the membrane circuit board.
5 Remove the membrane circuit board retaining
fasteners.
6 Carefully remove the membrane circuit board
from the platform control box lid.
Part No. 62401
1-2

Membrane Decal

How to Replace the Membrane
Decal
The membrane decal is a special decal that
consists of a decal with an electronic membrane
on the backside. The membrane contains touch
sensitive areas that, when pushed, activates the
machine functions. The membrane buttons
activate machine functions similar to toggle
switches, but do not have any moving parts.
1 Push in the Emergency Stop button to the
2 Remove the platform control box lid retaining
3 Carefully disconnect the two ribbon cables from
Genie S-100 • S-105 • S-120 • S-125
Section 7 • Repair Procedures
position at both the ground and platform
controls.
fasteners. Open the control box lid.
the membrane circuit board.
Electrocution hazard. Contact with
electrically charged circuits could
result in death or serious injury.
Remove all rings, watches and
other jewelry.
Component damage hazard.
Electrostatic discharge (ESD) can
damage printed circuit board
components. Maintain firm contact
with a metal part of the machine
that is grounded at all times when
handling printed circuit boards OR
use a grounded wrist strap.
REV B
OFF
7 - 6