Setting The Flush Volume; Activating/Deactivating Automatic Flushing - DURAVIT DuraSystem A2 Operating Instructions Manual

Setting the flush volume

You can adjust the flush volume on the toilet ceramic to achieve the optimum
flushing of the ceramic (increase the flush volume) or to prevent overspraying
(reduce the flush volume). You can make these settings for the large and short flush
(see table 1: Setting the flush volume).
> Press the "Long flush volume" or "Short flush volume" preselection button on your
remote control.
The right status LED on the control panel lights up blue. You now have 4 seconds to
change the flush volume step by step.
> Press the "Plus" setting button if you want to increase the flush volume.
> Press the "Minus" setting button if you want to decrease the flush volume.
The right status LED flashes blue each time you press the button. The flush volume is
increased/decreased by the corresponding steps.
Long flush
Short flush
Table 1: Setting the flush volume
AUTO

Activating/deactivating automatic flushing

The automatic flushing is always triggered when a user - i.e. a small child - does not
automatically flush the toilet themselves within 20 seconds of leaving it.
You can activate this function and also deactivate it again via your remote control
(see table 2: Automatic flushing).
> Press the "Automatic flushing" preselection button on your remote control.
The left status LED on the control panel lights up blue. You now have 4 seconds to
activate (deactivate) the automatic flushing.
> Press the "ON" ("OFF") setting button.
The right status LED flashes. The automatic flushing is activated (deactivated).
Automatic flushing
Table 2: Automatic flushing
42
Factory setting
Approx. 6 l
Approx. 3 l
Factory setting
Deactivated
Setting range
Approx. 4 l, 5 l, 6 l, 7 l
Approx. 3 l, 3,5 l, 4 l
Setting range
On/Off