Emptying The Cistern; Activating/Deactivating The Hygiene Flush; Setting The Hygiene Flush - DURAVIT DuraSystem A2 Operating Instructions Manual

Emptying the cistern

The cistern can be emptied if necessary.
> Press the long flush repeatedly until the cistern is completely empty.

Activating/deactivating the hygiene flush

The automatic hygiene flush triggers flushes at regular intervals to avoid stagnant
water in the pipe system. You can activate this function and also deactivate it again via
your remote control (see table 3: Setting the hygiene flush).
> Press the "Hygiene flush" preselection button on your remote control.
The left status LED on the control panel lights up blue. You now have 4 seconds to
activate (deactivate) the hygiene flush.
> Press the "ON" ("OFF") setting button.
The right status LED flashes. The hygiene flush is activated (deactivated).
The starting time for the hygiene flush is set the first time you activate it and a
hygiene flush occurs. For example, if you activated the hygiene flush at 6:00 pm, it will
always subsequently be triggered at 6:00 pm. The starting time can then be moved in
4-hour increments (see "Setting the hygiene flush" section). A general unit reset must
be carried out to completely reset the starting time (see "Reset" section).

Setting the hygiene flush

With the hygiene flush, you can set the time of the flush, the number of flushes and
the duration between the intervals (see table 3: Setting the hygiene flush).
> Press the "Starting time delay", "Number of flush packages" or the "Interval time"
preselection button on your remote control
The left status LED on the control panel lights up blue. You now have 4 seconds to
change the settings step by step.
> Press the "Plus" setting button if you want to increase the settings.
> Press the "Minus" setting button if you want to decrease the settings.
The right status LED flashes blue each time you press the button. The settings are
increased/decreased by the corresponding steps.
43