Table of Contents
Advertisement
MT-416-00
Combination Dash Display
Assuming there are no active faults detected (Diagnostic Trouble Code or DTC), on start up, the
display will show the current battery charge status and total accumulated hours of operation. If
there are active faults, then the display will scroll through all detected faults.
Note: Some single events will result in more than one DTC generated.
The following is a explanation of the different modes of the display depending on the current
operating conditions.
Direction Indicator
The display will indicate direction selected for about
2 seconds after the direction is selected then switch
to the BSI/Speed mode (see below).
Battery Status / Hour Meter
This mode will be active only when the direction
control switch is in the center OFF position.
At 15% charge remaining, the vehicle speed
will be limited and "BDI CUT" will be displayed.
TT-416 Stand Up Tow Tractor
Fault Messages (DTC)
This display will be in this mode any time the system detects a
fault condition.
It will show the DTC (Diagnostic Trouble Code) as well as a brief
description of the fault. IF there are multiple fault, the display will
flash each fault for about 2 seconds.
Shown here is DTC F59 which is a type of SRO fault.
It will be in this mode until all fault conditions are resolved.
A code table is provided in the "Troubleshooting" section in this
manual.
BSI / Speed
This is the mode shown during operation of the
vehicle.
Note: The speed is software selectable for
MPH or KPH and can be changed by
your dealer.
Page 21
Advertisement
Table of Contents
