Monte Carlo Fan Company Cupra 3CPR60 Series Owner's Manual And Installation Manual page 6

Remote Controller Operation
Remove the battery cover from the remote control transmitter and install
batteries. Replace the cover. This remote uses 2 1.5V/AAA batteries.
Note: If not using for long periods of time, remove battery to prevent
damage to remote transmitter, and store the remote transmitter away from
excess heat or humidity
Dimming, Non Dimming Setting (Only available for fans with light)
In the dimming mold, it is a light dimming selection and it is to be used with
dimmable luminaries. Press and hold the button to dim the light. The light will
cycle from bright to dim to bright until button is released. Light will maintain
last setting if turned off. Press and release the button quickly may turn light
on/off. The remote controller is set with dimming function at factory.
In ON/OFF (non-dimming mold), it is for light ON/OFF only (non-dimming
function).
Learn Function Setting
Restore power to your fan, press and hold the "SET" button to pair the
Transmitter and receiver. You must press the 'SET" button with in 60 seconds
of restoring power to the fan.
Note: Fan will operate at minimum speed after the setting.
Note: If the power is on already, you must turn the power off then turn the
power back for remote control setting.
The buttons on the remote control transmitter control the fan speed and light as follows.
Fan speed
1 = minimum speed
4 = medium speed
This button turns the fan off.
Forward/Reverse button- This button is to control direction of fan rotation. Press once
to change direction of the fan rotation. Fan must be running to reverse.
Breeze-
Press the Breeze button, fan will operates at high speed (6
change to 5 , 4 , 3 , 2
th th rd
2 , 3 , 4 , 5 , 6 repeat the cycle until the breeze mold is cancelled.
nd rd th th th
Breeze mold can be erased by pressing the buttons of power or speed control.
Note: This remote controller has auto resume function, the fan and light will maintain the last setting if
turned off with exception of the Breeze mold.
© 2020 Monte Carlo Fan Collections
2 = low speed 3 = medium low speed
5 = medium high speed
, 1 at intervals of 30 seconds, and then change it from Low speed (1
nd st
6 = high speed
) for 30 seconds, then automatically
th
6
DIM (D)
ON/OFF (O)
SET
SET
Battery cover
) to
st
1/2020