Blizzard POWER PLOW 8100PP Owner's Manual page 18

Control Lever Movement
From the center position, the control lever can be
moved in one of eight directions to control various
movements of the snowplow blade. To change from
one movement of the blade to another, the control
lever must be moved back to the center position
before selecting the desired function. Whenever the
lever is released, it should spring back into the center
position to stop any blade movement.
ON/OFF
RAISE
BUCKET
BLADE™
1
L
3
WING WING
IN/OUT IN/OUT
LOWER
Function Description of Operation
Move control lever toward top of control body to raise snowplow and cancel FLOAT mode. Function times
RAISE
out after 6.25 seconds.
Move the control lever toward bottom of control body to lower the snowplow. Release the lever to stop blade
LOWER
at desired height.
Move the control lever to LOWER position and hold for .75 second to activate this mode. The FLOAT light
in upper right corner of control face will illuminate. The blade will lower to the ground surface and follow
the contour of surface as it dips or raises. Function does not time out; however, control will shut down after
FLOAT
20 minutes of nonuse.
Move lever to RAISE position momentarily to cancel FLOAT. Angling left or right will interrupt (stop) FLOAT
function, but FLOAT will resume when angling is complete.
L Move the control lever straight to the left to move the blade to the angle left position to cast snow to the
(Angle Left) driver's left side. Function times out after 4.5 seconds.
R Move the control lever straight to the right to move the blade to the angle right position to cast snow to the
(Angle Right) driver's right side. Function times out after 4.5 seconds.
BUCKET Move the control lever toward the words BUCKET BLADE on the control face to extend both wings forward
BLADE™ into the BUCKET BLADE position. Function times out after 7.25 seconds.
Move the control lever toward the word COMPACT on the control face to draw both wings into the fully
COMPACT
retracted position. Function times out after 5.5 seconds.
Move the control lever toward the left side of LOWER on the control face to move the left wing. The fi rst
L WING time the lever is moved into the slot after the control is turned ON or another function is used, the wing will
IN/OUT extend. Repeated use of lever in the same slot, without using another function, results in movement in the
opposite direction from the previous movement. Function times out after 4.5 seconds.
Move the control lever toward the right side of LOWER on the control face to move the right wing. The fi rst
R WING time the lever is moved into the slot after the control is turned ON or another function is used, the wing will
IN/OUT extend. Repeated use of lever in the same slot, without using another function, results in movement in the
opposite direction from the previous movement. Function times out after 4.5 seconds.
Lit. No. 40691, Rev. 05
OPERATING YOUR SNOWPLOW
Float Light
(green)
FLOAT
COMPACT
2
R
4
WING WING
IN/OUT IN/OUT
Control Functions
Raise, Lower, Float, Angle
Moving the control lever in straight lines up and down
or from side to side on the control body will result in
the blade movements described in the following table.
NOTE: If control function times out before desired
blade movement is complete, release the lever
to the center position, then move back into the
desired function.
18 May 1, 2021