Mad Exclude Interface - H3C MSR Series Command Reference Manual

<Sysname> system-view
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] link-aggregation mode dynamic
[Sysname-Bridge-Aggregation1] mad enable
You need to assign a domain ID (range: 0-4294967295)
[Current domain is: 0]: 1
The assigned
MAD LACP only enable on dynamic aggregation interface.
# Enable LACP MAD on Route-Aggregation 1, a Layer 3 dynamic aggregate interface.
<Sysname> system-view
[Sysname] interface route-aggregation 1
[Sysname-Route-Aggregation1] link-aggregation mode dynamic
[Sysname-Route-Aggregation1] mad enable
You need to assign a domain ID (range: 0-4294967295)
[Current domain is: 0]: 1
The assigned
MAD LACP only enable on dynamic aggregation interface.
Related commands
irf domain

mad exclude interface

Use mad exclude interface to exclude a network port from being shut down when the IRF fabric
transits to the Recovery state upon detection of a multi-active collision.
Use undo mad exclude interface to configure the IRF fabric to shut down a network port when it
transits to the Recovery state upon detection of a multi-active collision.
Syntax
mad exclude interface interface-type interface-number
undo mad exclude interface interface-type interface-number
Default
All ports except the IRF physical interfaces and console ports shut down when the IRF fabric transits
to the Recovery state.
Views
System view
Predefined user roles
network-admin
Parameters
interface-type interface-number: Specifies a port by its type and number.
Usage guidelines
If a port must be kept in up state for special purposes such as Telnet connection, exclude the port
from the shutdown action. As a best practice to avoid incorrect traffic forwarding, do not exclude any
ports except for the ports used for Telnet.
Do not exclude the MAD-enabled aggregate interfaces and their member ports from the shutdown
action.
domain ID is: 1
domain ID is: 1
26