Mounting Instructions - Motomaster NAUTILUS 011-1985-4 Instruction Manual

MOUNTING INSTRUCTIONS

1 The charger may be permanently mounted and
connected in three different ways:
• Flat mount (floor)
• Wall mount, horizontal position
• Wall mount, vertical position
2
When choosing a location:
• Do not restrict the airflow under the
charger. Do not mount the charger next
to fuel tanks or below the waterline
of the boat. The charger is rainproof
and is approved for mounting on the
weatherdeck.
• To allow for proper air circulation, a
minimum of four inches of unobstructed
area must be permitted on all sides of the
charger.
• Choose a location such that the 6' (1.8 m)
cables can reach the battery location, and
that the AC power cord can reach a power
source.
WARNING
A spark near a battery may cause a battery explosion!
Four mounting holes have been provided
3
for secure installation. Using the charger
as a template, place the charger in the
selected location and mark each of
the four holes with a pencil. In a well
ventilated environment, drill the four
holes using a #9 (7/32˝) drill bit for use
with nuts and bolts OR with a 5/32˝ drill
bit for use with #10 self-tapping screws.
Use caution when drilling, to avoid
drilling into wires or other components.
Unit can be mounted with its back
against any flat surface, using #10 bolts,
nuts and lockwashers. Placement should
allow LEDs to be visible and allow for
maximum ventilation.
7