Table of Contents
Advertisement
Quick Links
INSTALLATION, OPERATION & MAINTENANCE MANUAL
Read this manual carefully before installing, operating or servicing these pump models.
Observe all safety information. Failure to comply with instructions may result in personal
injury and/or property damage. Please retain these instructions.
FAHRENHEIT
S-F& SX-F SERIES
SIDE DISCHARGE
Electric Submersible Pumps
Single Phase
115V & 230V
CAST IRON
SINGLE PHASE
S1500C-F
316 STAINLESS STEEL
SINGLE PHASE
SX750CSS-F
SX1500CSS-F
®
Version 9/18/2018
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for BJM Pumps FAHRENHEIT S-F Seires
Summary of Contents for BJM Pumps FAHRENHEIT S-F Seires
- Page 1 INSTALLATION, OPERATION & MAINTENANCE MANUAL ® FAHRENHEIT S-F& SX-F SERIES SIDE DISCHARGE Electric Submersible Pumps Single Phase 115V & 230V CAST IRON SINGLE PHASE S1500C-F 316 STAINLESS STEEL SINGLE PHASE SX750CSS-F SX1500CSS-F Read this manual carefully before installing, operating or servicing these pump models. Observe all safety information.
-
Page 2: Table Of Contents
TABLE OF CONTENTS INTRODUCTION ............................3 SAFETY ................................ 4 INSPECTION ..............................4 PRE-INSTALLATION INSPECTION ......................5 OIL FILL QUANTITY/TYPE ........................5 PUMP INSTALLATION ..........................7 POSITIONING THE PUMP ........................7 PUMP ROTATION ............................ 8 TYPICAL MANUAL WASTEWATER INSTALLATION ................. 9 TYPICAL AUTOMATIC WASTEWATER INSTALLATION ................. -
Page 3: Introduction
BJM Pumps® S-F & SX-F Series submersible pump. This manual also contains information to optimize performance and longevity of your BJM Pumps submersible pump. The F Series Fahrenheit® pumps are engineered to pump water based liquids up to 200°... -
Page 4: Safety
SAFETY Pump installations are seldom identical. Each installation and application can vary due to many different factors. It is the owner/service mechanics responsibility to repair, service, and test to ensure that the pump integrity is not compromised according to this manual. -
Page 5: Pre-Installation Inspection
The following are recommended installation practices/procedures for the pump. If there are questions in regards to your specific application, contact your local BJM Pumps distributor or BJM Pumps, LLC. PRE-INSTALLATION INSPECTION 1) Check the pump for damage that may have occurred during shipment. -
Page 6: Oil Fill Quantity/Type
For Storage Periods longer than 3 Years • Disassemble the pump and replace all of the O-rings, the Mechanical Seal, Seal Chamber Oil, and the Lip Seal. Repack the Bearings. • Remove the air check screw on the motor housing. Using an air compressor, pressurize the motor chamber to 13 psi and check for leaks using a spray bottle. -
Page 7: Pump Installation
Do not lift the pump by the power cable or discharge hose/piping. Proper lifting equipment (rope/chain) must be used. POSITIONING THE PUMP BJM Pumps, S-F & SX-F Series pumps are designed to operate fully submerged. Data sheets can be obtained online at www.bjmpumps.com or by calling BJM Pumps, LLC at 860-399-5937. -
Page 8: Pump Rotation
PUMP ROTATION If wired properly to the control, the single phase BJM Pumps S-F and SX-F Series pump should operate with the correct pumping rotation. Verification is recommended prior to installing into the sump basin. Two ways to check the correct pump rotation: 1. -
Page 9: Typical Manual Wastewater Installation
Damage to the pump or personal injury may result from alterations. The BJM Pumps, S-F and SX-F series pumps require a special control that contains the starting components, thermal sensor and Seal Minder connections. These pumps... -
Page 10: Typical Automatic Wastewater Installation
Use with approved motor control that matches motor input in full load amperes. “UTILLISER UN DÉMARREAR APPROUVÉ CONVENANT AU COURANT Á PLEINE CHARGE DU MOTEUR.” BJM Pumps has been evaluated for use with water or water based solutions. Please contact the manufacturer for additional information. - Page 11 Figure 1 SX750F-115 control Figure 2 SX750F-230, S1500F-230 and SX1500F-230 control...
-
Page 12: Optional Float Connection
OPTIONAL FLOAT CONNECTION BJM Pumps utilizes a control for all of the single phase “F” series pumps. The wiring diagram included in this manual (and with the control) should be followed to properly connect the pump power and sensor leads to the control, and the power supply to the control. -
Page 13: Pump Runs But Does Not Deliver Rated Capacity
The design of the “F” series high temperature pump models is unique and requires specific knowledge to perform the proper assembly. BJM Pumps recommends that all electrical service work be performed at the factory, or by a factory trained and certified repair technician, to insure that the materials and assembly methods meet BJM standards. - Page 14 12) Assemble the pump. STATOR REPLACEMENT OR ELECTRICAL REPAIR The BJM Pumps “F” Series designed pumps utilize unique construction methods and materials. The inner connection of all wiring requires use of a BJM wire connection kit. Included in this kit are specific instructions on how a qualified factory trained and certified repair technician can perform this work properly.
-
Page 15: Exploded View Of S1500C-F
EXPLODED VIEW OF S1500C-F... -
Page 16: Exploded View Of Sx750Css-F And Sx1500Css-F
EXPLODED VIEW OF SX750CSS-F AND SX1500CSS-F... -
Page 17: S-F Series Parts List
S-F SERIES PARTS LIST Pump Model S1500CF Pos. No. Part Description Item # 01-2 Stand 201986 Impeller 202098 Pump Housing 203008 Oil Chamber Cover 202213 08-1 O-Ring (Kit Only) Lip Seal FKM 202232 Mechanical Seal FKM 204240 Lower Ball Bearing 200958 14-2 Lower Bearing Retainer Clip... -
Page 18: Sx-F Series Parts List
SX-F SERIES PARTS LIST Pump Model SX750CSSF SX1500CSSF Pos. No. Part Description Item # Item # 01-2 Stand 201985 201987 Impeller** 202095 204631 Pump Housing 202176 202172 07-1 O-Ring (Kit Only) Oil Chamber Cover 202214 202214 08-1 O-Ring (Kit Only) Lip Seal FKM 202232 202232... -
Page 19: Single Phase Wiring Diagram
SINGLE PHASE WIRING DIAGRAM 115V & 230V MODELS S1500CF, SX750CSSF & SX1500CSSF... -
Page 20: Seal Minder® - Thermal Motor Sensor Switch
The cable is designed for a high temperature environment. The proper replacement part can be found parts list found in this manual. BJM Pumps, can supply a control with the Seal Minder and Thermal sensor switch option. BJM Pumps requires the Seal Minder and... -
Page 21: Warranty And Limitation Of Liability
BJM Pumps, LLC’s liability for any breach of this warranty shall be limited solely to replacement or repair, at the sole option of BJM Pumps, LLC, of any part or parts of the Product found to be defective during the warranty period, provided the Product is properly installed and is being used as originally intended. -
Page 22: Start-Up Report Form
START-UP REPORT FORM This form is designed to record the initial installation, and to serve as a guide for troubleshooting at a later date (if needed). BJM Pumps, LLC 123 Spencer Plain Road Old Saybrook, CT. 06475 Pump Owner’s Name... - Page 23 START-UP REPORT FORM Are guide rails vertical? Is base elbow installed level? Liquid level controls: Model Is control installed away from turbulence? Float Operation Check Tip lowest float (stop float), all pumps should remain off. Tip second float (and stop float), one pump comes on. Tip third float (and stop float), both pumps on (alarm on simplex).
- Page 24 START-UP REPORT FORM L1-L2 L2-L3 L3-L1 Amperage load connection, pump on FINAL CHECK Is pump secured properly? Was pump checked for leaks? Do check valves operate properly? Flow: Do pumps appear to operate at proper rate? Noise level: Acceptable Unacceptable Comments: Installed by: Company:...
-
Page 25: Notes
NOTES:... - Page 26 • Phone: (860) 399-5937 • Fax: (860) 399-7784 Email: sales@bjmpumps.com • Web Site: www.bjmpumps.com ® Fahrenheit is a trademark of BJM Pumps, LLC. BJM Pumps & Seal Minder is a registered trademark of BJM Pumps, LLC Copyright © 2009-2018 BJM Pumps, LLC. All rights reserved...
Need help?
Do you have a question about the FAHRENHEIT S-F Seires and is the answer not in the manual?
Questions and answers