Table of Contents
Advertisement
4. Tighten the slurry mold and valve box with short screws and
then apply slurry into the service around the valve box. Lay
the tiles.
4. 用短螺钉将灰浆模套与阀盒旋紧后,用灰浆填埋冲洗阀盒体
四周槽道，张贴瓷砖。
5. While using DC power, take out the battery box from the back
side of cover. Loose the screws of the battery box assy. with a
screw driver. Put 2 "AA" size alkaline batteries and
tighten the battery box's cover with the screws. Replace
the battery box . After connecting solenoid valve with
control box assy., install the cover as shown in the Fig.#5:
a. Buckle the sensor cover into the wall slightly above
bracket assy.
b. Press the sensor cover down along the wall and fit
tightly into the bracket assy.
c. Push upward with hex wrench and rotate anticlockwise
to lock the sensor cover.
5. 用于使用直流电源时，十字螺丝刀旋开电池盒盖螺丝，装入
2节5号碱性电池，拧紧电池盒盖的螺丝后，将电池盒组件放
到图5所示位置。连接电磁阀和控制盒组件的接插件,如图5
安装面板：
a. 将面板在固定板稍偏上方的位置扣向墙面；
b. 紧贴墙面向下扣紧面板，使面板和安装架卡牢；
c. 用六角扳手上顶后，逆时针旋转，锁定面板。（顺时针旋转
即可取下面板）
Note:
Don't mistake the polar of the batteries
and don't mix new and used batteries
together. When out of power, the indicator
will flash every 2 seconds and the sensor
will not work until new batteries are supplied.
When replacing the batteries, open the cover
of battery box and put in the new batteries.
Put on clean gloves when install sensor
cover to avoid surface damage by cement
or sand.
注意:
电池极性不能装反，新旧电池不能混用。电池
耗尽时，感应指示灯每隔2秒闪烁一次，感应
器停止工作，直至更换电池。更换电池时只需
打开电池盒盖装入新电池即可。
安装面板时应戴上干净的手套，以防水泥或沙
粒损伤表面。
1206437-T01-A
Valve Box
Screws
cover of Batteries Box
Batteries
Battery Box
Battery box Assy
a
Fig.#5
5
40
Tiles
Slurry Mold
b
Indicator
9
Advertisement
Table of Contents
