Table of Contents
Advertisement
Please directly reference to Step 3 when installinig DC.
Please match 16306T-NA AC power unit when installing
AC. The way of installation is as below.
CAUTION:
a. Outlet of AC power unit upward prohibited.
b. Do not connect 220V C power supply to DC wiring
terminal.
c. Do not damage the covering of AC power unit or
remove screws to avoid leakage.
安装直流型请直接参考第3步。
安装交流型请选配16306T-NA交流电源盒，安装方式如下：
警告：
a. 禁止将交流电源盒出线朝上安装。
b. 禁止将220V交流电源接入直流接线端。
c. 安装时严禁损伤交流电源盒外壳或移开电源盒盖螺
钉，以防止受潮漏电。
A. Fig.#1: AC power unit connection way 1:
AC power unit is directly connected to electric control box.
Fig.#2: AC power unit connection way 2:
AC power unit is connected to electric control box by
connection wire.
A. 图1：交流电源盒连接方式一：
交流电源盒与电控盒直接相连。
图2：交流电源盒连接方式二：
交流电源盒通过连接线与电控盒相连。
B. When installing the AC power unit in cassette, please
layout the bushing according to Fig.#3, and thread the
wire through the bushing.
Fig #3:connection sketch AC power unit install in cassette.
CAUTION: One AC power unit can supply two sensors at
most.
B. 将电源盒放在阀盒中时，如图示安装电工套管，管内装
入电线。
图3： 交流电源盒安装在阀盒内的连接示意图。
警告：一个交流电源盒最多可连接两个感应器。
1206437-T01-A
Outlet downwards
出线朝下安装
Connect to
Connect AC
sensor
Power Supply
接感应器
接交流电源
交流电源
16306T-NA
AC Power Unit
交流电源盒
AC
Connector
交流电源
接插件
16306T-NA
AC Power Unit
Connect with the same color wire,
交流电源盒
and protect connect area by insulation tape.
连接处用绝缘胶布包好
Connect 220V AC
接220V交流电
Outlet upwards
出线朝上安装
Connect AC
Power Supply
接交流电源
AC
Connector
接插件
Fig.#1
图1
Connector
Wire prepared
接插件
by customer
连接线用户自备
请按电线颜色对接
Fig.#2
图2
Bushing
电工套管
Fig.#3
图3
Connect to
sensor
接感应器
7
Advertisement
Table of Contents
