Troubleshooting - Utilitech UT-5412 Manual

TROUBLESHOOTING

PROBLEM
The lights do not
come on.
The lights come on
during the daylight.
The lights come
on for no apparent
reason.
7KH OLJKWV ÀDVK RQ
and off.
POSSIBLE CAUSE
1. The light switch is turned off.
2. 7KH ÀRRG OLJKW LV ORRVH RU
burned out.
3. The fuse is blown or the circuit
breaker is turned off.
4. Daylight turn-off is in effect.
5. The wiring is incorrect (new
installations).
6. The sensor is not covering the
area adequately.
1. The light control may be
installed in a relatively dark
location.
2. The light control is in TEST
mode.
1. The light control may be
sensing small animals or
DXWRPRELOH WUDI¿F
2. The range is set too high.
3. The light control is in MANUAL
mode.
1. Heat or light from the lamps
may be turning the light control
on and off.
2. +HDW EHLQJ UHÀHFWHG IURP RWKHU
objects may be affecting the
sensor.
3. The light control is in the TEST
mode and warming up.
4. The light may be leaking
WKURXJK WKH ÀRRG ODPS
UHÀHFWRUV
CORRECTIVE ACTION
1. Turn the light switch on.
2. 5HWLJKWHQ RU UHSODFH WKH ÀRRG OLJKW
3. Replace the fuse or turn on the
circuit breaker.
4. Re-check after dark.
5. Re-check the wiring.
6. Re-aim the sensor to cover desired
area.
1. Move the light to a brighter location
during the daylight hours.
2. Set the control switch to an ON-
TIME position.
1. Reposition the lamp away from the
sensor or nearby objects.
2. Reposition the sensor.
3. Switch to AUTO mode.
1. Reposition the lamps away from the
sensor.
2. Reposition the sensor.
3. Flashing is normal under these
conditions.
4. Make sure the metal lamp protectors
are installed.
8
Lowes.com