Installation Instructions - Utilitech UT-5412 Manual

PLANNING INSTALLATION
2. For under-eave installation, the sensor head must be
rotated as shown for proper operation and to avoid
the risk of electrical shock.
a. Swing the sensor head toward the clamp screw
joint.
b. Rotate the sensor head clockwise 180° so the
controls face down. If the sensor pops out of the ball
joint, loosen the clamp screw and push the sensor
back into the ball joint. Tighten the clamp screw
when done.

INSTALLATION INSTRUCTIONS

1. Mount the Light Control:
WARNING: Turn the power off at the circuit breaker
or fuse.
a. 5HPRYH WKH H[LVWLQJ OLJKW ¿[WXUH
b. Install the mounting strap (CC) using two screws
%% WKDW ¿W \RXU MXQFWLRQ ER[
c. The plastic hanger (GG) can be used to hold the
¿[WXUH ZKLOH ZLULQJ 7KUHDG WKH VPDOO HQG RI WKH
plastic hanger (GG) through the hole in the center
of the cover plate (B). The small end then goes into
one of the slots on the mounting strap (CC).
d. Route the light control's wires through the large
gasket (DD) holes.
e. 7ZLVW WKH MXQFWLRQ ER[ ZLUHV DQG ¿[WXUH ZLUHV
together. Connect the black wires together, the white
wires together, and connect the junction box ground
ZLUH WR WKH JUHHQ JURXQG VFUHZ RQ WKH ¿[WXUH
Secure with wire connectors (EE).
f. Align the light control cover plate (B) and gasket
(DD). Secure with the mounting bolt (AA).
g. 3XVK WKH UXEEHU SOXJ )) ¿UPO\ LQWR SODFH RYHU WKH
mounting bolt (AA).
2
1
CC
BB
Junction box ground
wire to green ground
screw on fixture.
4
Controls
Clamp Screw
Controls
Controls
EE
B
Black to black
DD
White to white
Lowes.com
FF
AA