Table of Contents
Advertisement
Assembling the Burners
•
Never attempt to operate the cooktop with any of the burner parts removed.
•
Do not attempt to adjust the burner air mixture settings. All adjustments are preset at the factory.
1. Remove the burner heads, burner rings, burner caps, and grates from their shipping packages.
2. Assemble the burners as shown below. When assembling the burner components, twist each piece back and forth
until it drops completely into place.
•
The burners will not function properly unless all of the burner pieces are correctly seated.
3. Gently set the grates on top of the spill tray. Make sure that the rubber feet are placed in the indentations located in
the spill tray.
Feet
Cap cover
(bottom view)
Line up this
notch with
the igniter
Igniter
Single Burner
Assembly
Burner and Grate Diagram for
DYCT304G, DYCT365G, HPCT304G, HPCT365G
Installation Instructions
WARNING
Grate
Burner head
Burner
base
Cap cover
Burner cap
Burner skirt
Wide side down
SimmerSear™
Burner Assembly
* The SimmerSear burner head is permanently attached to
the burner base. It cannot be removed by the user.
Burner head *
9
Advertisement
Table of Contents
