Dacor Epicure EG366SCH Installation Instructions Manual

Dacor Epicure EG366SCH Installation Instructions Manual

Dacor epicure eg366sch: install guide
Hide thumbs Also See for Epicure EG366SCH:

Advertisement

Installation Instructions

Epicure
Cooktop
®
Models: EG366, EG486
THIS APPLIANCE HAS BEEN TESTED IN ACCORDANCE WITH THE LATEST
EDITION OF ANSI Z21.1 STANDARD FOR HOUSEHOLD GAS APPLIANCES.
Part No. 102025 Rev. M

Advertisement

Table of Contents
loading

Summary of Contents for Dacor Epicure EG366SCH

  • Page 1: Installation Instructions

    Installation Instructions Epicure Cooktop ® Models: EG366, EG486 THIS APPLIANCE HAS BEEN TESTED IN ACCORDANCE WITH THE LATEST EDITION OF ANSI Z21.1 STANDARD FOR HOUSEHOLD GAS APPLIANCES. Part No. 102025 Rev. M...
  • Page 2: Table Of Contents

    Phone: (877) 337-3226 (U.S.A. and Canada) Monday — Friday 6:00 . to 4:00 All specifications are subject to change without notice. Dacor assumes no liability for changes to specifications. Table of Contents Installation Instructions ... 8 Cooktop Installation ... 8 Gas Line Connection ...
  • Page 3: Important Safety Instructions

    Use common sense and caution when installing, maintaining or oper- ating this or any other appliance. • Always contact the Dacor Customer Service Team about problems and conditions that you don’t under- stand. See Customer Service Information. Safety Symbols and Labels...
  • Page 4: General Safety Precautions

    Installations with less than 2 1/2” (64 mm) from the rear of the cooktop to a combustible material must use Dacor backguard model AEB3609, AEB3612, (for model EG366) AEB4809, AEB4812 (for model EG586) or a non-combustible material. See the lat- est version of ANSI Z223.1.
  • Page 5: Installation Requirements

    Installation Requirements WARNING • Observe all governing codes and ordinances during planning and installation. Contact your local building department for further information. • To prevent an electric shock hazard, the power sup- ply must meet the specifications stated below. The electrical and gas supply data on this page is for refer- ence only.
  • Page 6: Cabinet And Countertop Layout

    • For installations with a raised vent, install this appliance only with the approved Dacor raised vent models listed on page 6. Gas and Electric Service Location • The gas supply piping, gas shut-off valve and the elec- trical outlet must be located so they do not interfere with the cooktop when it is installed.
  • Page 7: Cabinet/Cutout Dimensions

    Installation Requirements Cabinet/Cutout Dimensions 10” (254 mm) to combustible side wall Min. both sides Cooktop platform Cabinet/Countertop Dimensions - Front View Hood 30” (762 mm) Cutout for Min. 18” (457 mm) utility access 1, 3 Min. Top of finished counter Cabinet tolerances +1/16”...
  • Page 8 Installation Requirements Cabinet/Countertop Dimensions (cont.) Cutout tolerances +1/16” -0 (+1.6 mm, 0) unless otherwise noted. Increase countertop and overhang additional 2 1/2” (64 mm) Min. for combustible rear wall above countertop countertop overhang 1/2” (13 mm) countertop overhang 24 5/8” (625 mm) 11 7/16”...
  • Page 9 Stiffener 3/8” Min. (10 mm) space behind raised vent chassis to clear stiffener Dacor approved raised vent Cabinet/Countertop with Raised Vent - Side View Non combustible rear wall recommended Open to below to allow for raised vent, gas and electrical connections 1”...
  • Page 10: Installation Instructions

    Crown burner caps (2) • Crown burner rings (2) • Crown burner heads (2) MAX GRIDDLE) • Knobs (4 standard, 2 • Dacor Stainless Steel Cleaner • Igniter cleaning brush • WOK ring • Griddle • Hold down bolts/washers (2 sets) •...
  • Page 11: Gas Line Connection

    Installation Instructions Gas Line Connection • Verify that the gas supply meets specifications before connection. See page 3. • The maximum gas supply pressure to the regulator must never exceed ½ pounds per square inch (psi) or 3.5 kPa. • Do not install or use the cooktop without the included gas regulator installed.
  • Page 12: Burner Component Installation

    Installation Instructions Burner Component Installation WARNING • Never attempt to operate the cooktop with any of the burner parts removed. • Do not attempt to adjust the burner air mixture set- tings. All adjustments are preset at the factory. • Remove the burner parts and grates from their shipping packages.
  • Page 13: Burner Knob Installation

    Installation Instructions Burner Knob Installation CAUTION Installing the cooktop knobs in the wrong position may result in damage to the cooktop griddle. The knobs for the center burners are marked with the maximum griddle settings. There are two (2) different types of knobs supplied with the cooktop.
  • Page 14: Verifying Proper Operation

    Be sure to have the model and serial numbers available when you call. See the inside HIGH cover for location. Dacor is not responsible for the cost of correcting problems caused by a faulty installation. Normal Flame Appearance...
  • Page 15: Installation Checklist

    • Proper installation is the responsibility of the hom- eowner. The importance of proper installation of your Dacor cooktop cannot be overemphasized. □ Is the electrical outlet for the cooktop grounded and located according to these instructions and in accor- dance with all applicable electrical codes? See pages 3 and 4.
  • Page 16: Wiring Diagram

    Wiring Diagram BLACK WHITE...
  • Page 17: Notes

    Notes...
  • Page 18 Notes...
  • Page 20 Dacor ● Phone: (800) 793-0093 ● FAX: (626) 403-3130 ● www.Dacor.com...

Table of Contents