Switching the video signal type (TV FORMAT)
TV FORMAT
NTSC
Switch the video signal type of the unit so that it matches to the format of your TV.
Settings
NTSC, PAL
Default
U.S.A., Canada, Korea, Brazil and General models: NTSC
Other models: PAL
Removing the limitation on HDMI video output
(MONITOR CHECK)
MONITOR CHECK
YES
The unit automatically detects resolutions supported by a TV connected to the HDMI OUT jack.
Disable the monitor check function if you want to specify a resolution in "Resolution" (p.133)
when the unit cannot detect the TV's resolution or when you want to specify a different
resolution than the detected resolution.
Settings
Enables the monitor check function. (Outputs video signals with a resolution
YES
supported by the TV only.)
Disables the monitor check function. (Outputs video signals with a specified
SKIP
resolution regardless of compatibility with the TV.)
Y
Reset to "YES" if the unit becomes inoperable because video from the unit cannot be displayed on the TV after
"MONITOR CHECK" has been set to "SKIP".
Selecting the HDMI 4K signal format (4K MODE)
4K MODE
MODE 1
Selects the format of signals input/output at the unit when HDMI 4K compatible TV and
playback device are connected to the unit.
Settings
Inputs/outputs 4K signals shown in the table below.
MODE 1
Depending on the connected device or HDMI cables, video may not be displayed
correctly. In this case, select "MODE 2".
MODE 2
Inputs/outputs 4K signals shown in the table below.
Format
RGB 4:4:4
YCbCr 4:4:4
4K/60, 50 Hz
YCbCr 4:2:2
YCbCr 4:2:0
RGB 4:4:4
4K/30, 25, 24 Hz
YCbCr 4:4:4
YCbCr 4:2:2
Y
When "MODE 1" is selected, use a Premium High Speed HDMI Cable or Premium High Speed Cable with Ethernet.
149
En
MODE 1
MODE 2
8 bit
10 bit
12 bit
8 bit
10 bit
,
-
-
,
-
-
,
-
,
,
-
,
,
-
,
,
-
,
,
12 bit