NEC PA1004UL-B User Manual page 43

Using the power cord stopper
To prevent the power cord from accidently removing from the AC IN of the projector, use the power
cord stopper.
CAUTION:
To prevent the power cord from coming loose, make sure that all the prongs of the power cord
are fully inserted into the AC IN terminal of the projector before using the power cord stopper
to fix the power cord. A loose contact of the power cord may cause a fire or electric shock.
NOTE:
• If you pull on the power supply cord while the connector is fixed, the main unit may fall down and be damaged
Installing the power cord stopper
① With the clamper facing the power supply cord, align the tip of the power supply cord stopper
with the hole below the AC IN terminal and push it in.
② Pass the power supply cord through the clamper and press the clamper to fix it.
③ Slide the clamper until the base of the power plug.
Disconnecting the power cord
① Pull to an appropriate position while pushing down the knob of the power cord stopper.
② Press down the knob on the clamper to open the clamper and take out the power cord.
③ Push and pull the fitted part of the power cord stopper from the left and right to remove it from
the main unit.
Knob
2. Projecting an Image (Basic Operation)
Clamper
Clamper
Knob
19