NEC PA1004UL-B User Manual page 162

Enabling Security [SECURITY]
This feature turns on or off the [SECURITY] function.
Unless the correct keyword is entered, the projector cannot project an image. (→ page 50)
NOTE:
• Your setting will not be affected even when [RESET] is done from the menu.
Selecting Communication Speed [COMMUNICATION SPEED]
This feature sets the communication speed for the PC Control port (D-Sub 9P). Make sure to set the
appropriate speed for the device to connect.
NOTE:
• Your selected communication speed will not be affected even when [RESET] is done from the menu.
[PC CONTROL(HDBaseT)]
Set this to [ON] when controlling the projector from a computer using RS-232C via an HDBaseT-
compatible transmitter (sold separately).
Setting ID to the Projector [CONTROL ID]
You can operate multiple projectors separately and independently with the single remote control
that has the [CONTROL ID] function. If you assign the same ID to all the projectors, you can conve-
niently operate all the projectors together using the single remote control. To do so, you have to
assign an ID number to each projector.
CONTROL ID NUMBER
CONTROL ID
NOTE:
• When [ON] is selected for [CONTROL ID], the projector cannot be operated by using the remote control that does not support the
[CONTROL ID] function. (In this case the buttons on the projector cabinet can be used.)
• Your setting will not be affected even when [RESET] is done from the menu.
• Pressing and holding the ENTER button on the projector cabinet for 10 seconds will display the menu for canceling the Control ID.
Select a number from 1 to 254 you wish to assign to your projector.
Select [OFF] to turn off the [CONTROL ID] setting and select [ON] to turn on the [CONTROL ID]
setting.
138
5. Using On-Screen Menu