Yale P-DL01 Fitting Instructions

Issue No: 01-2012
The world's favourite lock since 1843
School Street, Willenhall, West Midlands WV13 3PW
www.yale.co.uk
Tel: +44 (0) 1902 364647 E-mail: info@yale.co.uk
Push Button Door Lock
Fitting Instructions
Tools Required
Push button door lock
Required Cross Head
Drill
Drill Bits: Screwdriver
Ø10mm
Ø25mm
Pack Contents
1. Exterior Code Pad Assembly
1. 2. 3. 2. Interior Handle Assembly
3. Neoprene Seals. x 2
4. Latchbolt (60mm standard)
1 6
5. Spindles x 3 (only one is used)
2 7
3 8
6. Interior handle assembly xing bolts
4 9
(2 x 50mm)
5 0
(2 x 36mm)
X Z
Y C
7. Wood Screws x 4. Use with
Latchbolt and Strike plate
8. Latchbolt Support Post
9. Spare Colour Code Tumblers x 4
10. Tweezers
5.
4.
11. Strike Plate
12. Strike Box
13. Code Card
14. Exterior Code Pad Fixing lugs x 2
6. 7. 8.
9.
11. 12.
13.
Fitting Instructions
Before commencing installation check that all parts are
working correctly.
• Exterior Code Pad Assembly: Enter code from the
pre-set factory code card, and turn the knob to the right.
The knob should turn and return freely under spring
pressure. IF YOU INTEND TO CHANGE THE CODE
YOU SHOULD DO IT NOW. Refer to code changing
instructions.
• Interior Handle Assembly: Make sure that the lever
handle turns freely.
• Latchbolt: Check that the spring latch and
spindle hub
move freely.
New Installation:
1) Check the hand of your door
Viewed from the outside
INSIDE
(Code Pad side) your
door is left handed if the
LEFT HAND RIGHT HAND
hinges are on the right.
OUTSIDE
(Model P-DL01 and
10.
x2 x2
14.
Record your factory
pre-set code here
2) Apply the template
Select the desired position on the
door. Fold the template along the
dotted 60mm line and tape to the
door.
• Mark and drill all six 10mm holes as shown on the template.
• Use a chisel to clear the line of 4 x10mm holes into a
single slot.
• Mark the central point on the "centre line of latch" on the
edge of the door and drill a 25mm hole to a depth of 95mm
for the latchbolt.
• Insert the latchbolt into the the edge of the door and mark
around the face plate.
• Remove the latchbolt and cut a 3mm rebate so that the face
plate fits flush with the edge of the door.
• Fit the latchbolt with 2 wood screws.(Ensure that
the bevelled face of the latchbolt faces the door frame)