Battery Status - Webb WER16LIHP Operator's Manual & Parts List

BATTERY STATUS

The display on the battery indicates the remaining capacity, or if there are problems. There
are 4 LED lights on the battery.
CHARGING THE BATTERY
The battery must be charged prior to its first use.
Observe the mains voltage! The voltage of the power supply must correspond with the
•
data given on the nameplate of the battery charger. Battery chargers marked with 230v
can also be operated with 220v.
Put the battery into the Sanli charger. (DO NOT USE ANY OTHER CHARGER!)
•
Ensure the battery is correctly seated in the charger.
•
The GREEN charging light on the charger when the battery is connected to the charger.
•
• When all four LED lights on the battery are lit, the battery is fully charged.
Remove the battery.
•
Never charge the battery for more than 24 hours.
•
• Never disconnect the 3-pin plug from the power supply by pulling on the cable.
WHEN TO CHARGE THE BATTERY
During use, the battery LED lights will
go out, one by one. When the
machine will not start, the battery
requires charging.
Never leave the battery in the
charger when the battery is not
charging.
To check the battery capacity, press
the Battery Capacity Button next to
the LED Lights. The LED Lights will
illuminate according to the batteries
current power level. See chart
opposite:
LED
ALL LED'S
ARE LIT
LED 1, 2 & 3
ARE LIT
LED 1 & 2
ARE LIT
LED 1 IS LIT
BATTERY CAPACITY
75 - 100%
CHARGED
50 - 75% CHARGED
25 - 50% CHARGED
0 - 25% CHARGED