Table of Contents
Advertisement
BLADE MAINTENANCE
The cutting blade will continue to rotate
after the motor is switched off. Slicing is
possible if care is not taken. Wear
appropriate hand coverage.
Remove the battery & safety key from the
machine. Clean the top & underside of
the deck with a stiff brush, before any
maintenance is undertaken to the blade.
REMOVE THE BLADE
Block the rotation of the blade, using a
good-sized piece of wood, which the
blade cannot cut.
Hold the blade using gardening gloves
(not provided) & spanner wrench (not
provided) rotating anti-clockwise.
Remove the bolt, washer & blade. Dispose
of the old blade responsibly.
Never try to straighten a bent blade.
Replace a damaged worn or bent blade
as soon as possible. Use only genuine
parts or those approved by Webb.
Excessive vibration when mowing is a
good indication of a problem with the
cutting system.
WARNING
Vibration from a bent or damaged blade
can cause costly damage to the mower.
Working with an excessively worn blade
wastes fuel and can lead to injury if the
blade becomes detached from the
machine.
BLADE SHARPENING
For best mowing results, sharpen the
edges & balance the blade at least once
a year by an approved service dealer.
MOUNTING THE BLADE
Check all components are present, clean
and in good condition.
Check the correct alignment with the
blade boss. The blade must be positioned
precisely.
Attach a new blade, fastening with the
washer & blade bolt. Ensure that the
blade is correctly positioned on the blade
boss and then firmly tighten the bolt,
clockwise.
TROUBLE SHOOTING
ISSUE
CORRECTION
1. Check the battery &
Motor does
not run
safety key are
inserted correctly.
2. Start on short grass or
on an area which has
already been mown.
3. Clean the discharge
chute/housing, the
blade must rotate
freely.
4. Correct the cutting
height.
Reduced
1. Correct the cutting
motor
height.
2. Clean the discharge
power
chute/housing, the
blade must rotate
freely.
3. Blade is blunt. Have
re-sharpened or
replaced by an
approved service
dealer.
1. The mulch plug is in
The grass
collector
position, remove for
does not fill
collection.
2. Correct the cutting
completely.
height.
3. Allow the lawn to dry.
4. Blade is blunt. Have
re-sharpened or
replaced by an
approved service
dealer.
5. Clean the air vents on
the motor housing.
6. Clean the discharge
chute/housing, the
blade must rotate
freely.
Advertisement
Table of Contents
