Table of Contents
Advertisement
Maintenance
Before serving the machine always
disconnect the machine from the power
supply by removing the power cable
from the socket !
Repair must only be carried out by a
GERIMA trained technician!
Improperly repaired machines are
hazzard!
•
Increased risk of injury
•
Machine does not function correctly!
Hot carbide inserts and milling head!
•
Burn hazzard!
•
Wear protective gloves when replacing
the carbide inserts!
Maintenance plan:
Part to be serviced
Service 1:
Ventilation slots
Service 2:
Height adjuster thread
Service 3:
Carbide inserts
Service 1:
To ensure that the machine can be cooled properly, the
ventilation slots must be kept clean. To avoid damaging
the motor winding it is important that no foreign matter
(e.g. chips) enter the motor compartment. Clean the
motor compartment regularly by blowing compressed air
through it.
Disposal of components removed from the machine:
All machine parts, operating and auxiliary materials must be disposed of in accordance with
the applicable statutory provisions.
©
Type of mainte-
Service
nance work
Daily
Machine
operator
Clean and lubricate
Trained
as necessary
technician
Rotate or replace as
Machine
necessary
operator
Maintenance / Disposal
Blunt tool can cause damage!
•
Blunt tool can overload the machine!
•
Inspect milling tools regulary for signs of
wear.
•
Wear protective gloves when changing or
readjusting the carbide inserts!
Maintenance
procedure
Clean ventilation
Brush, cloth,
slots
compressed air
Disassemble
Teflon spray
guiding plate unit
See page
Torx-wrench
14
Service 2:
Remove the screw for height clamping, lift the guiding
plate unit, clean the mounting thread, lubricate the thread
with teflon spray and then re-assemble in reverse order.
Materials
Order-nr.
required
0109.007.10-00005
See page
T15
14
17
Advertisement
Table of Contents
