Gerima SMA 20 AEF-24.K1 Operating Manual page 10

Requirements to be met by operating staff:
The machine may only be operated by appropri-
ately trained persons who have been instructed in
the use of the machine and are authorized to oper-
ate it.
Operators must have read and understood this
operating manual and must act in accordance with
it. The functions of the operating personnel, i.e.
what an operator is or is not allowed to do, must be
clearly specified.
Special qualifications are required for the following
activities:
• Commissioning: The machine may only be com-
missioned by the manufacturer.
• Operational training: Training in the use of the
machine must be provided either by the manu-
facturer or by persons who have received appro-
priate instruction.
• Fault elimination: Faults may only be dealt with
by appropriately qualified technical staff or by the
manufacturer's service personnel.
• Maintenance: Maintenance work may only be
performed by technical staff who have received
appropriate instruction.
• Cleaning: The machine may only be cleaned by
persons who have received appropriate instruc-
tion.
• Servicing: The machine may only be serviced by
appropriately qualified technical staff or by the
manufacturer's service personnel.
• Repair: The machine may only be repaired by
appropriately qualified technical staff or by the
manufacturer's service personnel.
• Decommissioning: Decommissioning of the ma-
chine may only be performed by appropriately
qualified technical staff or by the manufacturer's
service personnel.
©
Basic safety instructions
Risk of injury from hot metal chips:
•
Hot chips are ejected from the
machine at high speed.
Improper use can cause serious injury:
•
Make sure you always have a
firm footing when working with
the machine.
•
Never touch the milling tool when
the machine is running.
• Never use the machine above head height.
• Ensure the switch is in the off-position before
connecting to power source. After use de-
energize the machine by disconnecting it from
the power supply!
• Only Milling against the rotating direction = upcut
milling
Improper use can damage equipment and pro-
perty:
• Risk of machine being damaged
or destroyed.
• Never lift or carry the machine by
its power cable.
• Make sure the cable is directed behind and away
from the machine. Do not lay the cable over
sharp edges.
• Always use genuine GERIMA spare parts and
accessories.
10