Intended Use - Gerima SMA 20 AEF-24.K1 Operating Manual

Cleaning the machine and disposal information:
All substances and materials used
must be handled appropriately and
accordance with all relevant statuto-
ry provisions and legislation.
The machine must only be cleaned
after it has been switched off!
Machine noise:
The continuous sound power level emitted by the
machine at the installation site is greater than > 84
dB (A).
Operating personnel must wear ear
protection!
Residual risks:
• The machine was plant and constructed with all
suitable devices to guarantee the safety and
health of the operator.
• The machine is covered to prevent the risk of
contact with moving parts.
• However residual risks still exist.
• As already mentioned the cutting area is protec-
ted as far as possible but there is an opening
portion through which the processing material
must be introduced.
• It is possible that the operator reaches in this
area with his hands.
Always keep your hands as far as
possible away from the cutting
area!
Always oberserve the safety rules
to minimize the residual risks!
Be aware that the machine may be
a source of residual mechanical or
electrical energy. Appropriate pre-
cautions for dealing with these ha-
zardous energy sources must be
taken when instructing operating
personnel on the use of the machi-
ne.
©
Basic safety instructions / Intended use
The hand-held beveling machine SMA 20 AEF-
24.K1 / 14.K1 may only be used for work and ma-
terials described in the section ‚intended use'.
Do not use the machine to work on
materials containing asbestos!
The SMA 20-AEF is a hand-held, electrically powered
beveling machine intended:
•
For machining workpieces made of steel,
cast steel, fine-grained steel, stainnless steel,
aluminium, aluminium alloy, brass and plas-
tic.
•
For commercial use in industrial settings and
in the skilled-trades.
•
For preparing K-, V-, X-, and Y-shaped
welding grooves.
•
For creating visible edges in plant and me-
chanical engineering work.
•
For rounding off of edges for an optimal pain-
ting preperation or as a scratch and bump
protection.
13