Canon XH A1 Instruction Manual page 99

• If necessary, turn on the DV conversion and select whether to convert a tape recorded in HD to SD with the
following procedure.
Open the menu and select [SIGNAL SETUP]. Select [HD DOWN-CONV], select a setting
option and close the menu.
4 Using the VIDEO Terminal
If connecting to a TV, set the input selector to VIDEO. If connecting to a VCR, set the input selector to LINE.
Refer also to the instruction manual of the TV or VCR.
Open the terminal cover
We recommend powering the camcorder from a household power outlet.
Connection to a Normal TV or Monitor (Non-HDTV/HiVision)
1 Using the COMPONENT OUT Terminal
Refer to the connection diagram in the previous section (
Select the appropriate component video signal depending on the TV or monitor you connect.
Open the menu and select [SIGNAL SETUP]. Select [COMP. OUT], select a setting option
and close the menu.
2 Using the VIDEO Terminal
Refer to the connection diagram in the previous section (
If connecting to a TV set the input selector to VIDEO. If connecting to a VCR, set the input selector to LINE.
Refer also to the instruction manual of the TV or VCR.
If connecting to a TV set with a 4:3 aspect ratio, change the [LETTERBOX] setting appropriately.
Open the menu and select [SIGNAL SETUP]. Select [LETTERBOX], set it to [ON] and
close the menu.
We recommend powering the camcorder from a household power outlet.
To use the A/V terminal, set the video
output selection switch to A/V1. To use
the BNC teminal (VIDEO2), set it to V2.
Signal flow
STV-290N Stereo Cable (supplied)
INPUT
yellow
white
red
98).
99).
E
VIDEO
L
AUDIO
R
99