Canon XH A1 Instruction Manual page 98

2. Open the menu and select [SIGNAL SETUP]. Select [SDI OUTPUT] and set it to [ON].
3. From the same [SIGNAL SETUP] submenu select [SDI SPEC.]. Select [AUTO] or
[SD LOCKED] to match the video output you wish to use.
4. Close the menu.
Using the COMPONENT OUT Terminal
2
Open the terminal cover
Set the switch to the
A/V1 position
Select the appropriate component video signal depending on the TV or monitor you connect.
Open the menu and select [SIGNAL SETUP]. Select [COMP. OUT], select a setting option
and close the menu.
Using the HDV/DV Terminal
3
Open the terminal cover
• When connecting the camcorder to a monitor TV that supports DV, you may need to carry out a procedure
on the TV to recognize the camera. Refer to the instruction manual of the TV or monitor.
98
Signal flow
STV-290N Stereo Cable (supplied)
Signal flow
DTC-1000 Component Video Cable
(supplied)
CV-150F/CV-250F
DV Cable (optional)
yellow
VIDEO
white
L
AUDIO
red
R
INPUT
Pr/Cr
red
Pb/Cb
blue
green
Y
4-pin
6-pin