Returning To A Pre-Marked Position - Canon XH A1 Instruction Manual

Returning to a Pre-marked Position

If you wish to return to a particular scene later, mark the point with the zero set memory, and the tape will
stop at that point when you rewind/fast forward the tape.
This function is operated with the wireless controller.
ZERO SET MEMORY
1. During playback, press the ZERO SET MEMORY button at the point you wish to return
to later.
• The tape counter is reset to 0:00:00 and the
• To cancel, press the ZERO SET MEMORY button again.
2. After you finish playing back the tape, stop and rewind it.
• If the tape counter shows a negative value, fast forward the tape instead.
• The tape stops automatically at "0:00:00" and the
• The tape counter changes to time code.
The zero set memory may not function correctly if the time code has not been recorded
consecutively.
The zero set memory function may not work correctly if you mix recordings in HDV and DV
standards on the same tape.
REW button
button
mark appears.
STOP button
mark disappears.
E
101