Fractional / Decimal Representation Of Height Unit - Sokkia SDL30 Operator's Manual

Waving:
Repeat:
Page 2
Tracking: The instrument repeats coarse measurements
Note:
• When is pressed in Set-out mode, the Measurement
conditions setting screen can be displayed.
16.2 Fractional/Decimal Representation of Height
Units
You can set the fractional/decimal display format for
displaying height values.
The following options are available when using "m" as the unit:
* 0.0001m: Up to 4 decimals (when measuring mode is
0.001m:
The following options are available when using "ft" as the unit:
* 0.001ft:
0.01ft:
Only the following option is available when using "inch" as
1/8:
For measurement
function
The instrument repeats fine measurements
until the operator presses
until the operator presses
"single", "repeat", "average" or "Waving")/Up to 3
decimals (when measuring mode is "tracking")
Up to 3 decimals ("single", "repeat", "average" or
"Waving")/Up to 2 decimals ("tracking").
Up to 3 decimals (when measuring mode is
"single", "repeat" or "average")/Up to 2
decimals (when measuring mode is "tracking").
Up to 2 decimals ("single", "repeat" or "average")/
Up to 1 decimal ("tracking").
the unit:
**-**-*/
*
using Wave-and-Read
or
Measure
or
Measure
.
.
57