Notes:
• Point number input
Step 4:
Step 6:
• Attribute setting
Step 6:
• Go and Return setting
Step 4:
• Storing backsight elevation
Steps 3 and 10: Even after power off, backsight elevation is
• Reviewing stored data
Steps 4 and 6: Press
• Manually inputting measurement data
Steps 4 and 6: Press
Press
to ready the instrument for point
number input.
Press
twice to ready the instrument for
point number input.
(See "8.4 Flow of Recording Data".)
Press
to ready the instrument for attribute
setting. (See "8.4 Flow of Recording Data".)
Press
to display the Go and Return Setting
Screen. (See "8.3 Double-run Measurement".)
stored or turning point is stored as the next
backsight elevation.
same as the value in the setting out elevation
mode, the backsight elevation is stored to
whichever mode is set last. (See "11.3 Setting
Out Elevation".)
to display the contents of the
selected JOB. (See "13.1 Data Check and Edit".)
.
Measurement data can now be
input manually. (See "8.4 Flow of Recording
Data".)
Since this value is the
41