Table of Contents
Advertisement
Installation with cables coming out sideways
12) Fasten the OUTSIDE UNIT on the base plate and lead the two cables through one
of the 4 existing grooves, according to the position as shown on Fig. 12.
WARNING: When performing this operation, do not draw the two cables forcefully, as this
might pull them out.
13) Connect the two cables coming from the centre of the OUTSIDE UNIT to the two
supplied extensions, waterproofing the connectors using the two pieces of heat-
shrinking tube.
14) Accomodate the cables into a protection raceway up to the point where the cables
go into the vehicle, using the suitable supplied fairlead.
15) Seal the fairlead carefully so as to prevent any infiltration by water.
Vers. 003
Magic Sat Easy
Assembly instructions
9
Hide quick links:
Advertisement
Table of Contents
