Teleco MAGIC SAT EASY Installation Manual And User's Manual page 12

Assembly instructions
WARNING
This technical note is to call the attention of the installation personnel to certain
details of Magic Sat Easy installation. During installation, you must take the
following precautions:
The power supply cable must come directly from the battery and be of a minimum cross-
section of 5 sq.mm. Only the Magic Sat Easy must be connected to this cable; all the other
devices must be connected to another power supply cable.
The cable connecting the driving unit to the Magic Sat Easy Control Box must NEVER be
cut for any reason whatsoever: should the cable turn out to be too long, wind the extra part
into a coil in a free area of the vehicle.
Leave a little cable in the driving unit area; should any technical operation be required, it
will make it easier to remove the driving unit.
Also, before checking its operation, we suggest you make sure that:
The outside converter (also called LNB) has been installed properly and locked into its
plastic lock nut. Remember that the outside converter has its own assembly position which
must be complied with. Otherwise you will not receive any signal.
The preset assembly position of the converter is along the median line of the dish (Fig. A)
and in this configuration the Magic Sat Easy system operates properly in most European
countries. If however you are in areas which are very far from the orbital position of the
satellite, you could need to adjust the angle of the converter. In particular, if you wish to
receive any transmission from the Astra 19E, Astra 28E or Hot Bird 13E satellites and you
are in Portugal or Morocco, you should adjust the converter angle as shown on Fig. B2,
whereas if you are in Turkey, you should set the converter on the B1 position for the same
satellites.
Below you will find a table to help you setting the best angle Place Position HotBird13E
Astra 19E ASTRA 28E
Magic Sat Easy Vers. 003
12