Using Bosch Vms Operator Client - Bosch DIVAR IP 7000 Installation Manual

26 en | System setup - first steps
2.
Notice!
For the tasks that cannot be done with Configuration Wizard, and for detailed information
concerning Configuration Wizard itself, refer to the Bosch VMS manual (see Additional
Documentation and client software).
5.5

Using Bosch VMS Operator Client

Use Bosch VMS Operator Client to verify the live, recording and playback functionality of
DIVAR IP.
To verify live image functionality in the Operator Client
1.
2.
3.
4.
To verify recording functionality in the Operator Client
4
To verify playback functionality in the Operator Client
4
To perform further functionalities refer to the Bosch VMS manual.
References to the manual are described in Additional documentation and client software, page
30.
2016.07 | V2 | DOC
Follow the wizard and observe the instructions on the screen.
On the Bosch VMS default screen, double-click the Operator Client icon
application starts.
Enter the following and click OK.
User name: admin
Password: no password required (if not set with the wizard)
Connection: 127.0.0.1
Click the live image icon. The Logical Tree with the cameras is displayed.
Select a camera and drag it to an image window. The image of the camera is displayed if
the camera is assigned correctly.
Note:
Cameras in the image window with a red dot in the camera's icon are viewed live.
Cameras in the Logical Tree with a red dot in the camera's icon are recording.
The time line moves if the camera is viewed in playback mode.
Installation Manual
DIVAR IP 7000 (2U)
. The
Bosch Sicherheitssysteme GmbH