Installing The Motherboard; Installing The Air Shroud - Bosch DIVAR IP 7000 Installation Manual

44 en | Maintenance
To replace the front port panel:
1.
2.
3.
4.
5.
6.
10.9

Installing the motherboard

Motherboard problems will be handled by trained support people only.
10.10

Installing the air shroud

The air shroud does not require screws for its installation.
Notice!
If a 16 DIMM (13.68" x 13") motherboard is used, it is necessary to use the optional
MCP-310-82502-0N air shroud.
To install the air shroud:
1.
2.
3.
2016.07 | V2 | DOC
1 DVD-ROM
Turn off and unplug the unit.
Remove the chassis cover.
Disconnect the power and data cables from the front port panel to other chassis
components including the motherboard and backplane.
Remove the old port panel by depressing the release tab, then pulling the unit out of the
chassis.
Insert the new front port panel unit in the slot until the tab locks into place.
Connect the data and power cables to the backplane and motherboard.
Make sure that your air shroud matches your chassis model.
Turn off the system and remove the cover.
Place the air shroud in the chassis. The air shroud fits behind the two fans closest to the
power supply.
1
2
Installation Manual
DIVAR IP 7000 (2U)
2
Front port panel
Bosch Sicherheitssysteme GmbH