Preparing Installation - Advantech OW-1000A Owner's Manual

2.3

Preparing Installation

Before installing OW-1000A for outdoor application or hard-to-reach
location, we recommend configuring and test all the devices first.
For configuring the OW-1000A, please follow the quick steps below to
power up the OW-1000A. Refer to Figure 2-2 for steps 1 through 5.
Figure 2-2
Step1 : Connect the DC plug of the AC/DC power adapter into the DC
Input Port of Inline Power Injector and the wall-mount plug into a
power outlet or power strip (refer to page 6). The Power LED on the
Inline Power Injector will light up.
Step2 : Run the cross-over type uplink Ethernet cable from Data Input
Port (refer topage 6) to the Ethernet port on a PC.
Step3 : Connect the 30m CAT 5 Ethernet cable into the OW-1000A unit.
Hand tighten the connector.
Step4 : Connect the remaining end of the 30m CAT 5 cable into the PoE
labeled AP/Bridge. This is the power side of the PoE that will power up
the OW-1000A.
When the OW-1000A receives power over the Ethernet cable, the
OW-1000A will start its boot up sequence and the Active LED on the
Inline Power Injector will light up.
You can configure the OW-1000A via HTML browser, such as Microsoft
Internet Explorer or Netscape Navigator from a remote host or PC.
9