Chapter 2 Hardware Installation; Product Kit; System Requirements - Advantech WLAN-9100 Manual

Chapter 2 Hardware Installation

This chapter describes initial setup of the WLAN-9100.

2-1 Product Kit

Before installation, make sure that you the following items:
¢
The WLAN-9100 Wireless LAN Access Point..........................................x 1
¢
Quick Start Guide ......................................................................x 1
¢
Power Adapter...........................................................................x 1
¢
Product CD (or Floppy Disk).............. ..........................................x 1
If any of the above items are not included or damaged, please contact your local dealer for
support.

2-2 System Requirements

Installation of the WLAN-9100 Wireless LAN Access Point requires:
1. An AC power outlet (100~240V, 50~60Hz) which supplies the power for the Access
Point.
2. A 10/100 Base-T (UTP) Ethernet cable drop.
Note: (Only if you want to re-configure the WLAN-9100 Wireless LAN Access Point instead
of using factory default configuration...) A PC with an available RS-232C port runs the
configuration program.
-4-