Basic Configuration; Basic Configuration Steps; Logging Into The Web Interface - Advantech OW-1000A Owner's Manual

2.4

Basic Configuration

2.4.1

Basic Configuration Steps

Note: All setting changing must Reboot the device after click
Apply
This section describes a two-step SYSTEM configuration procedure to
setup OW-1000A.
Step1 : Modify the factory-default parameters on the web page
"/Network/Network/", and click APPLY to save the changes.
Step2 : Modify the factory-default parameters on the web page
"/WIRELESS/Wi-Fi 1", and click APPLY to save the changes, than
click "/SYSTEM/Reboot/"Reboot to take effect on the previous
configuration changes.
2.4.2

Logging into the Web Interface

The OW-1000A supports access to the configuration system through the
use of an HTTP Interface.
Web Configuration
Before configuring OW-1000A, the user needs to know the IP Address
assigned to the unit. When shipped from the factory, the IP Address
192.168.1.1 was assigned to the OW-1000A by default. To start a web
connection, use http://192.168.1.1
Web Access Procedures
Once you identify the IP Address assigned to OW-1000A, use web
browser to configure OW-1000A through the HTTP Interface. The
following procedure explains how to configure each item.
Step1 : Open your browser and enter the IP Address
Step2 : Press <ENTER> key and the OW-1000A Login screen appears
as shown in Figure 2-3.
10