Fixing Pressure Roller; Preparation For Removing The Fixing Pressure Roller; Removing The Fixing Pressure Roller - Canon LBP3300 Series Service Manual

Chapter 3
5) Remove the spring [1].
6) Remove the fixing film.
- 4 Bosses [3] (2 each at right and left)
- 2 pressure plates [4] (Right and left)

3.5.3 Fixing Pressure Roller

3.5.3.1 Preparation for removing the fixing pressure
roller
1) Detach the left cover. (page 3-1)Reference[Detaching the left cover]
2) Detach the right cover. (page 3-1)Reference[Detaching the right cover]
3) Detach the rear cover. (page 3-1)Reference[Removing the rear cover
unit.]
4) Detach the upper cover. (page 3-2)Reference[Detaching the upper cover
unit]
5) Remove the video controller PCB. (page 3-5)Reference[Removing the
video controller PCB]
6) Remove the USB PCB. (page 3-5)Reference[Removing the USB PCB]
7) Remove the fixing assembly. (page 3-8)Reference[Removing the fixing
assembly]
8) Remove the fixing film. (page 3-9)Reference[Removing the fixing film]

3.5.3.2 Removing the fixing pressure roller

1) Slide out the fixing inlet guide (lower) [1] in the direction of arrow.
- A screw [2]
2) Turn the shaft support [1] in the direction of arrow to remove.
- A claw [2]
3) Remove the pressure roller [3].
3-10
F-3-68
F-3-69
F-3-70
0011-4966
0011-4967
F-3-71