Secure The Rail Assemblies To The Cabinet; Installing The Rear End Of The Rail; Installing The Front End Of The Rail - Dell EMC VxFlex Ready Node 14G Hardware Installation Manual

2U1N Configuration Equipment Installation

Secure the rail assemblies to the cabinet

Hardware Installation Guide
68
Figure 26 Installing the rear end of the rail
5. For the front end piece, rotate the latch outward and pull the rail forward until
the pins slide into the flange, and release the latch to secure the rail in place.
Figure 27 Installing the front end of the rail
6. Repeat the preceding steps to install the right rail assembly.
The supplied screws and washers are used to secure the rail assemblies to the front
and rear of the cabinet.
Note
For square hole cabinets, install the supplied conical washer before installing the
screw. For unthreaded round hole cabinets, install only the screw without the conical
washer.