Installing A Network Module; Installing A Network Module In The Switch; Safety Warnings; Equipment That You Need - Cisco C9200L-24T-4X-A Hardware Installation Manual

Installing a Network Module

•
•
•
•

Installing a Network Module in the Switch

Safety Warnings

This section includes the installation cautions and warnings. Translations of the safety warnings are available
in the Regulatory Compliance and Safety Information for Cisco Catalyst 9200 Series Switches .
Read this section before you install a network module.
Caution
Proper ESD protection is required whenever you handle equipment. Installation and maintenance personnel
should be properly grounded by grounding straps to eliminate the risk of ESD damage to the equipment.
Equipment is subject to ESD damage whenever you remove it.
Warning Only trained and qualified personnel should be allowed to install, replace, or service this equipment. Statement
1030
Warning
Do not reach into a vacant slot or chassis while you install or remove a module. Exposed circuitry could
constitute an energy hazard. Statement 206

Equipment That You Need

• Ratcheting torque screwdriver with a number-2 Phillips head that exerts up to 15 pound-force inches
Installing a Network Module in the Switch, on page 33
Removing a Network Module, on page 36
Finding the Network Module Serial Number, on page 36
Installing and Removing Pluggable Transceiver Modules, on page 37
(lbf-in.) of pressure
C H A P T E R
Cisco Catalyst 9200 Series Switches Hardware Installation Guide
3
33